I have a 10 bar VDO oil pressure sender (2 pins, resistive sensor, one to ground, one to gauge). According the info I found on the internet it should work in the range of 10-180ohm. However I'm not sure if the VDO resistance is linear to the pressure it read.
The SYL-1813B has setting for 0-375ohm pressure sensors. I suppose this is the one that I should use. What is the correct setting for the 10 bar VDO sender?
If I'm calculating the range linear it should be -0.59bar at 0ohm and 22.06bar at 375ohm. Is that the correct setting?