Powder Coating Oven Controller Kit w/ Light&Fan Control (7200 W)

Starting at: $300.00


  • Model: KIT-PCO-LF
  •  
     



    Qty.

    Please Choose:

    Output Connector Option




    Download




    Manual Option








Product Description:

This is our standard 30A KIT to DIY your control panel for powder coating oven w/ light and fan installed. The PID controller has built-in timer function, so that it can hold set temperature at a certain amount of time and then shut off power; press the blue push buttom momentarily, it will reset the timer and start aother batch. During a batch, one can use a manual switch to turn ON or OFF the heater when needed, and a yellow indictor shows the element status. The alarm buzzer can be used as either temp alarm or finishing alarm; when it goes off, it can also be easliy muted by a manual switch. Wiring diagram and punching specification are available after purchase.
 
If you do not need light & fan control, please go to KIT-PCO.
 
 
This kit includes each of the following:
  • 10x8x6" Wall mount enclosure with hanger and 40 A heat sink.
  • Dual-line display PID controller with built-in timer function.
  • 40 A Solid State Relay.
  • Flashing Buzzer for temperature/timer alarm.
  • Yellow LED for indicating heater status.
  • Red illuminated Selector switch for alarm silence.
  • Yellow illumincated switch for element control.
  • Blue illuminated momentary push-button switch for reseting timer.
  • Green illuminated selector switch for light and fan control.
  • Oven temperature probe w/ mounting screw (both sensor and cable are rated for 900 º F).
  • Leviton 240 V 30 A NEMA L6-30R Socket for heater connection.
  • NEMA 5-15R 120V 15A Panel Mount Socket for light and fan connection.
  • 30 A Strain Relief Power Cord Connector for hard-wiring the power line. 
  • 2 Pole 32 A Main Breaker as power switch.
  • DIN Rail Terminal Block Kit for power system building. 
  • Engraved Panel Tags for labeling.
 
The kit does not include:
  • Heating element.
  • Input power cord, 4 conductor (10/4).
  • Wiring and wiring fittings.
 Note:
  • The enclosure only has one precut for 1/16 DIN controller on the front panel.
  • If you the kit for gas burner, please contact us

Warranty: 6 months.


The final look of a complete project is below:



Front View


Bottom View 


This product was added to our catalog on Monday 15 May, 2017.

Copyright © 2017 auberins.com. Contact sales@auberins.com