This is the mini RTD connector used on our WS-1500E
series plug-n-play controllers. It would be much easier to use the RTDCON
instead of this mini size one if the size is not critical.
The panel mount connector is useful for small temperature control projects, if you want the temperature probe to be disconnected when not in use. However, it is hard to find nowadays because most manufactures use circuit board mount connector to reduce the assembly cost.
This three pin connector can be mounted on the instrument panel. It can be used for three wire RTD sensor. The connector contains spring locks to prevent disconnecting from accidental pulls on the sensor cable.
Left: Female Connector (For cable).
Right: Male Connector (For panel mounting)
Middle: Connector Pair.
Connector outer diameter
12.1 mm (0.475”)
Mounting hole diameter
8 mm (0.315”)
Maximum mounting panel thickness
3.75 mm (0.147”)
This product was added to our catalog on Friday 31 August, 2012.