Compact Digital Timer

The DT-100 is a very compact, general purpose timer. It is suitable for building small control boxes or control panels where space is limited. Although it is small in size, DT-100 has two timers, three different timer format and an output relay to trigger small loads such as flashing buzzer. The timer can be started when it is powered up. It can also be started via the Reset key. The two time segments share the same units, either in second, minute or hour. The OUT light is the relay indicator.

 
To view/change each time segment, please short press SET key. If the display is flashing, you will be able to use up or down arrow key to change it. To view/change each time parameter, please hold SET key for 2 seconds. P0 is the parameter for timer format and P1 is the parameter for timer working mode. Note: Every time you change the timer setting, please wait for 6 seconds (it takes 6 seconds for the timer memory to save the change).
 

Timer range: 0~999 seconds, 0~999 minutes or 0~999 hours.

Timer trigger: power on or front key pad.

Power supply: 110 ~ 220 V AC.

Operating temperature: 0-50 °C.

Mounting cutout: 72 x 40 mm

Dimension: 79 x 26 x 43 mm
 

P0 = 0: timer format is in seconds.

P0 = 1: timer format is in minutes.

P0 = 2: timer format is in hours.
 

P1 = 0 (Single delay): Only T1 is running. Relay stay open when T1 is counting and will become closed once T1 finished counting.

P1 = 1 (Single delay): Only T1 is running. Relay stay closed when T1 is counting and will become open once T1 finished counting.

P1 = 2 (Dual timer no cycle): When T1 is running, relay stay closed; when T2 is running, relay becomes open.

P1 = 3 (Dual timer no cycle): When T1 is running, relay stay open; when T2 is running, relay becomes closed.

P1 = 4 (Cycle): When T1 is running, relay stay closed; when T2 is running, relay becomes open.

P1 = 5 (Cycle): When T1 is running, relay stay open; when T2 is running, relay becomes closed.