This is 19mm momentary metal push button switch with RGB tri-color LEDs. There is a RGB tri-color LED ring located on the front. 7 metal contacts are located on the back of this switch: three for switch action (NO, NC and common). four for RGB LED (red, green, blue and common anode). LED is rated as 6.3 VDC.
To use LED: connect 3-6.3 VDC to the common anode contact (marked as C+), and connect the negative of DC power to any of red, green or blue contact. Then the target color LED will be lit up. No external resistor is needed. If you need to use it with higher voltage, an exteranl resistor is needed.
This maintained push button switch can be used to control the 110 V or 220 V power to devices such as controllers, buzzers, or small fans. It has one pair of normally open (NO) contacts and one pair of normally closed (NC) contacts. Both are rated for 5 Amp at 250 VAC. Wiring connectors (7 pieces) are included.
Note 1: Wiring harness (wire connector, 7-lead) is offered for this switch. Please see the option above.
Note 2: 3 weeks lead time may apply for 100 pcs order. For questions of our switches (different LED color, size, wholesale pricing, etc), feel free to contact us.
Specifications:
| |
SW18-UL-RGB |
| LED color: |
Tri-color (Red, Green, Blue) |
| LED voltage: |
6.3 VDC |
| LED common: |
Common Anode |
| Switch Operation Current Rating: |
5 A /120 VAC, 3 A / 240 VAC |
| Panel thickness: |
1 - 10 mm (0.39") |
| Head diameter: |
22 mm (0.87") |
| Cutout diameter: |
19.5 mm (3/4 inch) |
| Operation type: |
Momentary |
| Contact type: |
1 NO, 1 NC |
| Ingress Protection: |
IP67 |
| Body Material |
Stainless steel |
Note: the nut and the gasket should both be installed behind the panel.
Wiring connectors
Wiring connectors (7 pieces) are included.
Dimensions
Dimensions of SW18 switch (all number in the diagram is labeled in mm)
Pin assignment and color code for optional wiring harness
Keyword: Vandal-proof, Vandal-resistant switch
This product was added to our catalog on Friday 08 November, 2019.
