Powder Coating Oven Controller Kit ft. Light&Fan (240V 75A 18KW)

The KIT-PCO504 DIY kit is a deluxe 75A do-it-yourself control panel for a large powder coating oven with light and fan control. Utilizing a PID temp controller, an independent timer and a limit-control thermometer; this panel can show set temp, run temp, set time and run time at the same time. The dual-channel output design gives more freedom on your oven element control: You can simply turn one channel OFF if you just want to run half power. A pair of voltmeter and ammeter shows the system power status. The alarm buzzer is used for temp-ready alarm, timer finishing alarm and high-temp alarm. One can mute either alarm by its assigned mute switch.

Wiring diagram and other installation files are available to download after purchase. 

This DIY kit/control panel is designed by Auber Instruments. US seller with US support team. Copyright © Auber Instruments. 

CLICK HERE TO SEE THE FINAL LOOK OF AN ASSEMBLED PANEL.

This kit includes each of the following:

• 16x12x8" Wall mount enclosure with silk screen label, complete precut and a 80A heat sink.
• Dual-line display PID controller.
• Dual-Line general purpose timer.
• Dual-Line limit-control thermometer.
• Three pieces of 40 A Solid State Relays, each for one heater channel.
• One flashing buzzer and three alarm mute switches.
• Mini digital volt and amp meter for showing system power.
• Three yellow 2-position selector switches for element control.
• Blue illuminated push button for resetting timer.
• Green illuminated push button for light and fan control.
• Two oven temperature probe w/ mounting screws (both the sensor and cable are rated for 900 º F).
• 1/2-inch EMT conduit fittings for all output connections.
• Strain Relief Power Cord Connector for hard-wiring input power. 
• Side-mount breaker for overcurrent protection.
• Three DIN Rail mounted 2P 32A contactors.
• DIN Rail Components for power distribution.

• This control panel is designed for North America 240V AC power lines which require four line power connections (L1, L2, Neutral and Ground), please verify your power supply before purchase. Please contact us if you have questions. 
• This control system is designed for heating elements (resistive load) only, not for gas burners or propane heaters. If you want to use the system for a gas burner or the other types of heaters, please contact us before purchase; otherwise, your purchase may not be covered by our warranty. 
• Electrical assembly is required for this DIY kit. The assembled panel is available here: PCO504.
• Input power cord (SOOW 4/4) is not included because each user may have different hook up requirements.
• The heating element is not included.
• Light/fan is not included.
• Optional hanger set is offered. 
• Default sensor cable length is 11 ft (3.5m). If you need a longer sensor cable, please contact us. 

Warranty: 6-month limited warranty. See here for details.

Photos for the included enclosure with holes and knockouts. Please click on the photo below to enlarge

Front view of the enclosure

Bottom view of the enclosure

Back view of the enclosure

Left view of enclosure

Right view of the enclosure

Optional Wiring Kit is available.

Optional Hanger

Manual Download Tip: 
The instruction manual & installation documents are only available for downloading for customers who already purchased the kit. After purchasing the kit, please log in your account, go to your order history and find the order for this kit, then you can find a downloadable link to get the zip file of the manuals. If you have issues downloading the zip file, please use Chrome browser. For customers who checkout the kit without creating accounts, please use the original email address in your order and proceed with "forgot your password".