Powder Coating Oven Controller Kit ft. Light&Fan (240V 50A 12KW)

The KIT-PCO404 DIY kit is a standard 50A build-it-yourself control panel for the powder coating oven with light and fan control. Utilizing a PID temp controller and an independent timer, this panel can show set temp, run temp, set time and run time at the same time. The dual-channel output design gives more freedom on your oven element control: You can simply turn one channel OFF if you just want to run half power. A pair of voltmeter and ammeter shows the system power status. The alarm buzzer is used for both temp alarm and finishing alarm. One can mute either alarm by its assigned mute switch.

Wiring diagram and other installation files are available to download after purchase. 

If you do not need the light & fan control features, please go to KIT-PCO304. 

This DIY kit/control panel is designed by Auber Instruments. US seller with US support team. Copyright © Auber Instruments. 

This kit includes each of the following:

• 12x10x8" Wall mount enclosure with silk screen label, complete precut and a 75A heat sink.
• Dual-line display PID controller.
• Two pieces of 40 A Solid State Relays, each for one heater channel.
• Dual-Line general purpose timer.
• Two flashing buzzers and one alarm indicator.
• Mini digital volt and amp meter for showing system power.
• Four black 2-position selector switches for element control and alarm silence.
• Blue illuminated push button for resetting timer.
• Green illuminated push button for light and fan control.
• Oven temperature probe w/ mounting screws (both the sensor and cable are rated for 900 º F).
• 1/2-inch EMT conduit fittings for all output connections.
• Strain Relief Power Cord Connector for hard-wiring input power. 
• Side-mount breaker for overcurrent protection.
• Two DIN Rail mounted 2P 32A contactors.
• DIN Rail Terminal Block Kit for power distribution.

• This control panel is designed for North America 240V AC power lines which require four line power connections (L1, L2, Neutral and Ground), please verify your power supply before purchase. Please contact us if you have questions. 
• This control system is designed for heating elements (resistive load) only, not for gas burners or propane heaters. If you want to use the system for a gas burner or the other types of heaters, please contact us before purchase; otherwise, your purchase may not be covered by our warranty. 
• Electrical assembly is required for this DIY kit. The assembled panel is available here: PCO404.
• Input power cord (SOOW 6/4) is not included because each user may have different hook up requirements.
• The heating element is not included.
• Light/fan is not included.
• Default sensor cable length is 6 ft (2m). An optional longer cable length 11 ft (3.5m) is also available. If you need a longer sensor cable, please contact us. 
• Optional hanger set is offered. 
• KIT-PCO402 DIY Kit (Enclosure with Minor Defects) is limited stock here. 

Warranty: 6-month limited warranty. See here for details.

Protection plan for this kit is available here. 

Assembly Video

CLICK HERE TO SEE THE FINAL LOOK OF AN ASSEMBLED PANEL.

Front view of enclosure.

 

Bottom view of enclosure.

 

Back view of enclosure.

 

Left view of enclosure.

 

Right view of enclosure.

 

Optional Wiring Kit is available.  

Optional Hanger