39x39mm Punch Set

Model: pd-3939

Starting at: $190.00

Please Choose:

Draw Stud Option

Add to Cart:

PD-3939 is a punch and die set for punching a rectangular cutout in 39 mm x 39 mm. It comes with a semi-circular-shaped 22 mm draw stud, either in a M20 x 1.5 metric thread or a UNF 3/4"-16 thread. It is designed to make a cutout hole for panel-mount gauges that need a 71 x 39 mm cutout, such as DVA-120, DA-100, DV-100. (Need two punches to make the cutout in 71 x 39 mm.)

This punch and die set requires a hydraulic punch driver. Please check the thread type in the cylinder ram and select a compatible draw stud.

Parts shown in the photo are PD-3939 punch & die set, a metric (M20 x 1.5) draw stud, and a cap.

Draw Stud Options

Draw stud options are described in the table below and shown in the image.

Description	Parts	Draw Stud Length	Thread	Note
Metric M20 x 1.5	A	100 mm	M20 x 1.5	Fits hydraulic knockout punch drivers with metric thread.
UNF 3/4"-16	B	100 mm	UNF 3/4"-16	Fits "Geenlee-style" drivers with UNF 3/4"-16 thread.
UNF 3/4"-16 (for Greenlee)	C	123 mm	UNF 3/4"-16	Fits Greenlee 746 Ram with recessed thread.
UNF 3/4"-16 (for Greenlee) with a spacer	C&D	123 mm	UNF 3/4"-16	Fits both Greenlee and "Greenlee-style" drivers.

Specifiications

Die Cutout Size: 39 x 39 mm.
Draw Stud Cross-Section: 22 mm diameter x 18 mm.
Draw Stud Length: 100 mm or 123 mm.
Cap Thread: M18 x 1.5
Ram Cylinder Thread: M20 x 1.5 or UNF 3/4"-16

[PDF] How to Use Auber's Punch and Die Sets.